![]() ![]() Whenever I try that with Simplif圓D, the finished product has so many zits as to be unusable. On a lark, I tried running my test print (just a 3" high, 1" diameter tube with threaded cap) through Cura, at maximum fine (.06mm) settings. I took their default settings for the Robo R2, and have slowly tweaked them to my liking, except for the zits. I use Simplif圓D because I really can't stand Cura. I've upped my retraction, told it to avoid retracting on layer changes, upped the coasting, and even reduced the multiplier to 90%. ![]() I have been spending A LOT of time recently fighting with zits/blobbing on the exterior surface of my prints, especially when it's a curved surface.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |